When you have determined that there is no user error involved, and replication still either does not work at all or is unstable, it is time to send us a bug report. We need to obtain as much information as possible from you to be able to track down the bug. Please spend some time and effort in preparing a good bug report.
If you have a repeatable test case that demonstrates the bug, please enter it into our bugs database using the instructions given in Section 1.6, “How to Report Bugs or Problems”. If you have a “phantom” problem (one that you cannot duplicate at will), use the following procedure:
Verify that no user error is involved. For example, if you update the replica outside of the replication threads, the data goes out of synchrony, and you can have unique key violations on updates. In this case, the replication thread stops and waits for you to clean up the tables manually to bring them into synchrony. This is not a replication problem. It is a problem of outside interference causing replication to fail.
Ensure that the replica is running with binary logging enabled (the
log_binsystem variable), and with the
--log-slave-updatesoption enabled, which causes the replica to log the updates that it receives from the source into its own binary logs. These settings are the defaults.
Save all evidence before resetting the replication state. If we have no information or only sketchy information, it becomes difficult or impossible for us to track down the problem. The evidence you should collect is:
All binary log files from the source
All binary log files from the replica
The output of
SHOW MASTER STATUSfrom the source at the time you discovered the problem
The output of
SHOW REPLICA | SLAVE STATUSfrom the replica at the time you discovered the problem
Error logs from the source and the replica
Use mysqlbinlog to examine the binary logs. The following should be helpful to find the problem statement.
SHOW REPLICA | SLAVE STATUS.
shell> mysqlbinlog --start-position=log_pos log_file | head
After you have collected the evidence for the problem, try to isolate it as a separate test case first. Then enter the problem with as much information as possible into our bugs database using the instructions at Section 1.6, “How to Report Bugs or Problems”.