MySQL 5.7 Release Notes
This section lists error codes, names, and messages that are written to the cluster log in the event of transporter errors.
- 0x00
TE_NO_ERROR
No error
- 0x01
TE_ERROR_CLOSING_SOCKET
Error found during closing of socket
- 0x02
TE_ERROR_IN_SELECT_BEFORE_ACCEPT
Error found before accept. The transporter will retry
- 0x03
TE_INVALID_MESSAGE_LENGTH
Error found in message (invalid message length)
- 0x04
TE_INVALID_CHECKSUM
Error found in message (checksum)
- 0x05
TE_COULD_NOT_CREATE_SOCKET
Error found while creating socket(can't create socket)
- 0x06
TE_COULD_NOT_BIND_SOCKET
Error found while binding server socket
- 0x07
TE_LISTEN_FAILED
Error found while listening to server socket
- 0x08
TE_ACCEPT_RETURN_ERROR
Error found during accept(accept return error)
- 0x0b
TE_SHM_DISCONNECT
The remote node has disconnected
- 0x0c
TE_SHM_IPC_STAT
Unable to check shm segment
- 0x0d
TE_SHM_UNABLE_TO_CREATE_SEGMENT
Unable to create shm segment
- 0x0e
TE_SHM_UNABLE_TO_ATTACH_SEGMENT
Unable to attach shm segment
- 0x0f
TE_SHM_UNABLE_TO_REMOVE_SEGMENT
Unable to remove shm segment
- 0x10
TE_TOO_SMALL_SIGID
Sig ID too small
- 0x11
TE_TOO_LARGE_SIGID
Sig ID too large
- 0x12
TE_WAIT_STACK_FULL
Wait stack was full
- 0x13
TE_RECEIVE_BUFFER_FULL
Receive buffer was full
- 0x14
TE_SIGNAL_LOST_SEND_BUFFER_FULL
Send buffer was full,and trying to force send fails
- 0x15
TE_SIGNAL_LOST
Send failed for unknown reason(signal lost)
- 0x16
TE_SEND_BUFFER_FULL
The send buffer was full, but sleeping for a while solved
- 0x21
TE_SHM_IPC_PERMANENT
Shm ipc Permanent error
Note
Transporter error codes 0x17 through 0x20 and 0x22 are reserved for SCI connections, which are not supported in this version of NDB Cluster, and so are not included here.