This section describes how to install MySQL Enterprise Audit, which is
implemented using the
audit_log plugin. For
general information about installing plugins, see
Installing and Uninstalling Plugins.
If installed, the
audit_log plugin involves
some minimal overhead even when disabled. To avoid this
overhead, do not install MySQL Enterprise Audit unless you plan to use it.
To be usable by the server, the plugin library file must be
located in the MySQL plugin directory (the directory named by
variable). If necessary, configure the plugin directory location
by setting the value of
plugin_dir at server startup.
The plugin library file base name is
audit_log. The file name suffix differs per
platform (for example,
.so for Unix and
.dll for Windows).
To load the plugin at server startup, use the
--plugin-load-add option to name
the library file that contains it. With this plugin-loading
method, the option must be given each time the server starts.
For example, put the following lines in the server
my.cnf file, adjusting the
.so suffix for your platform as necessary:
my.cnf, restart the server
to cause the new settings to take effect.
Alternatively, to load the plugin at runtime, use this
statement, adjusting the
.so suffix for
your platform as necessary:
INSTALL PLUGIN audit_log SONAME 'audit_log.so';
INSTALL PLUGIN loads the plugin,
and also registers it in the
system table to cause the plugin to be loaded for each
subsequent normal server startup without the need for
mysql> SELECT PLUGIN_NAME, PLUGIN_STATUS FROM INFORMATION_SCHEMA.PLUGINS WHERE PLUGIN_NAME LIKE 'audit%'; +-------------+---------------+ | PLUGIN_NAME | PLUGIN_STATUS | +-------------+---------------+ | audit_log | ACTIVE | +-------------+---------------+
If the plugin failed to initialize, check the server error log for diagnostic messages.
If the plugin has been previously registered with
INSTALL PLUGIN or is loaded with
--plugin-load-add, you can use
--audit-log option at server
startup to control plugin activation. For example, to load the
plugin at startup and prevent it from being removed at runtime,
use these options:
[mysqld] plugin-load-add=audit_log.so audit-log=FORCE_PLUS_PERMANENT
If it is desired to prevent the server from running without the
audit plugin, use
with a value of
FORCE_PLUS_PERMANENT to force server startup
to fail if the plugin does not initialize successfully.
For additional information about the parameters used to
configure operation of the
see Audit Log Options and System Variables.
Audit log file contents are not encrypted. See Section 6.4.2, “MySQL Enterprise Audit Security Considerations”.