This section describes how to install and configure the clone plugin. For remote cloning operations, the clone plugin must be installed on the donor and recipient MySQL server instances.
For general information about installing or uninstalling plugins, see Section 5.6.1, “Installing and Uninstalling Plugins”.
To be usable by the server, the plugin library file must be
located in the MySQL plugin directory (the directory named by
variable). If necessary, set the value of
plugin_dir at server startup to
tell the server the plugin directory location.
The plugin library file base name is
mysql_clone.so. The file name suffix differs
by platform (for example,
.so for Unix and
.dll for Windows).
To load the plugin at server startup, use the
--plugin-load-add option to name
the library file that contains it. With this plugin-loading
method, the option must be given each time the server starts.
For example, put these lines in your
file, adjusting the plugin library file name extension for your
platform as necessary. (The plugin library file name extension
depends on your platform. Common suffixes are
.so for Unix and Unix-like systems,
.dll for Windows.)
my.cnf, restart the server
to cause the new settings to take effect.
cannot be used to load the clone plugin when restarting the
server during an upgrade from a previous MySQL version. In
such cases, attempting to restart the server with
raises the error [ERROR] [MY-013238] [Server] Error
installing plugin 'clone': Cannot install during
upgrade. To keep this from happening, upgrade the
server before attempting to start the server with
Alternatively, to load the plugin at runtime, use this
statement, adjusting the
.so suffix for
your platform as necessary:
INSTALL PLUGIN clone SONAME 'mysql_clone.so';
INSTALL PLUGIN loads the plugin,
and also registers it in the
system table to cause the plugin to be loaded for each
subsequent normal server startup without the need for
To verify plugin installation, examine the Information Schema
PLUGINS table or use the
SHOW PLUGINS statement (see
Section 5.6.2, “Obtaining Server Plugin Information”). For example:
mysql> SELECT PLUGIN_NAME, PLUGIN_STATUS FROM INFORMATION_SCHEMA.PLUGINS WHERE PLUGIN_NAME = 'clone'; +------------------------+---------------+ | PLUGIN_NAME | PLUGIN_STATUS | +------------------------+---------------+ | clone | ACTIVE | +------------------------+---------------+
If the plugin fails to initialize, check the server error log for clone or plugin-related diagnostic messages.
If the plugin has been previously registered with
INSTALL PLUGIN or is loaded with
--plugin-load-add, you can use
--clone option at server startup to control
the plugin activation state. For example, to load the plugin at
startup and prevent it from being removed at runtime, use these
[mysqld] plugin-load-add=mysql_clone.so clone=FORCE_PLUS_PERMANENT
If you want to prevent the server from running without the clone
--clone with a value of
FORCE_PLUS_PERMANENT to force server startup
to fail if the plugin does not initialize successfully.
For more information about plugin activation states, see Controlling Plugin Activation State.