2.2 Installing MySQL Shell on Linux

Note

Installation packages for MySQL Shell are available only for a limited number of Linux distributions, and only for 64-bit systems.

For supported Linux distributions, the easiest way to install MySQL Shell on Linux is to use the MySQL APT repository or MySQL Yum repository. For systems not using the MySQL repositories, MySQL Shell can also be downloaded and installed directly.

Installing MySQL Shell with the MySQL APT Repository

For Linux distributions supported by the MySQL APT repository, follow one of the paths below:

• If you do not yet have the MySQL APT repository as a software repository on your system, do the following:

  • Follow the steps given in Adding the MySQL APT Repository, paying special attention to the following:

    • During the installation of the configuration package, when asked in the dialogue box to configure the repository, make sure you choose MySQL 9.0 as the release series you want.

    • Make sure you do not skip the step for updating package information for the MySQL APT repository:

      sudo apt-get update

  • Install MySQL Shell with this command:

    sudo apt-get install mysql-shell

• If you already have the MySQL APT repository as a software repository on your system, do the following:

  • Update package information for the MySQL APT repository:

    sudo apt-get update

  • Update the MySQL APT repository configuration package with the following command:

    sudo apt-get install mysql-apt-config

    When asked in the dialogue box to configure the repository, make sure you choose MySQL 9.0 as the release series you want.

  • Install MySQL Shell with this command:

    sudo apt-get install mysql-shell

Installing MySQL Shell with the MySQL Yum Repository

For Linux distributions supported by the MySQL Yum repository, follow these steps to install MySQL Shell:

• Do one of the following:

  • If you already have the MySQL Yum repository as a software repository on your system and the repository was configured with the new release package mysql90-community-release.

  • If you already have the MySQL Yum repository as a software repository on your system but have configured the repository with the old release package mysql-community-release, it is easiest to install MySQL Shell by first reconfiguring the MySQL Yum repository with the new mysql90-community-release package. To do so, you need to remove your old release package first, with the following command :

    sudo yum remove mysql-community-release

    For dnf-enabled systems, do this instead:

    sudo dnf erase mysql-community-release

    Then, follow the steps given in Adding the MySQL Yum Repository to install the new release package, mysql90-community-release.

  • If you do not yet have the MySQL Yum repository as a software repository on your system, follow the steps given in Adding the MySQL Yum Repository.

• Install MySQL Shell with this command:

  sudo yum install mysql-shell

  For dnf-enabled systems, do this instead:

  sudo dnf install mysql-shell

Installing MySQL Shell from Direct Downloads from the MySQL Developer Zone

RPM, Debian, and source packages for installing MySQL Shell are also available for download at Download MySQL Shell.