To check a
MyISAM table, use the following
This finds 99.99% of all errors. What it cannot find is
corruption that involves only the data
file (which is very unusual). If you want to check a table,
you should normally run myisamchk without
options or with the
-s (silent) option.
This finds 99.999% of all errors. It first checks all index entries for errors and then reads through all rows. It calculates a checksum for all key values in the rows and verifies that the checksum matches the checksum for the keys in the index tree.
This does a complete and thorough check of all data
-e means “extended check”).
It does a check-read of every key for each row to verify
that they indeed point to the correct row. This may take a
long time for a large table that has many indexes. Normally,
myisamchk stops after the first error it
finds. If you want to obtain more information, you can add
-v (verbose) option. This causes
myisamchk to keep going, up through a
maximum of 20 errors.
This is like the previous command, but the
-i option tells
myisamchk to print additional statistical
In most cases, a simple myisamchk command with no arguments other than the table name is sufficient to check a table.
Copyright © 1997, 2014, Oracle and/or its affiliates. All rights reserved. Legal Notices