Multiple SQL nodes.
The following are issues relating to the use of multiple MySQL
servers as NDB Cluster SQL nodes, and are specific to the
NDBCLUSTER storage engine:
Stored programs not distributed. Stored procedures, stored functions, triggers, and scheduled events are all supported by tables using the
NDBstorage engine, but these do not propagate automatically between MySQL Servers acting as Cluster SQL nodes, and must be re-created separately on each SQL node. See Stored Programs in NDB Cluster.
No distributed table locks. A
LOCK TABLESworks only for the SQL node on which the lock is issued; no other SQL node in the cluster “sees” this lock. This is also true for a lock issued by any statement that locks tables as part of its operations. (See next item for an example.)
ALTER TABLE operations.
ALTER TABLEis not fully locking when running multiple MySQL servers (SQL nodes). (As discussed in the previous item, NDB Cluster does not support distributed table locks.)
If any of the management servers are running on the same host, you must give nodes explicit IDs in connection strings because automatic allocation of node IDs does not work across multiple management servers on the same host. This is not required if every management server resides on a different host.
When a management server starts, it first checks for any other management server in the same NDB Cluster, and upon successful connection to the other management server uses its configuration data. This means that the management server
--initialstartup options are ignored unless the management server is the only one running. It also means that, when performing a rolling restart of an NDB Cluster with multiple management nodes, the management server reads its own configuration file if (and only if) it is the only management server running in this NDB Cluster. See Section 7.5, “Performing a Rolling Restart of an NDB Cluster”, for more information.
Multiple network addresses. Multiple network addresses per data node are not supported. Use of these is liable to cause problems: In the event of a data node failure, an SQL node waits for confirmation that the data node went down but never receives it because another route to that data node remains open. This can effectively make the cluster inoperable.
It is possible to use multiple network hardware
interfaces (such as Ethernet cards) for a
single data node, but these must be bound to the same address.
This also means that it not possible to use more than one
[tcp] section per connection in the
config.ini file. See
Section 5.3.9, “NDB Cluster TCP/IP Connections”, for more