Do not lock any tables that you are using
INSERT DELAYED. An
INSERT DELAYED in this case
results in an error because the insert must be handled by a
separate thread, not by the session which holds the lock.
Tables in the
cannot be locked with
TABLES, except the
The following statements are prohibited while a
LOCK TABLES statement is in
CREATE TABLE ...
DROP VIEW, and DDL statements on
stored functions and procedures and events.
For some operations, system tables in the
mysql database must be accessed. For example,
HELP statement requires the
contents of the server-side help tables, and
CONVERT_TZ() might need to read
the time zone tables. The server implicitly locks the system
tables for reading as necessary so that you need not lock them
explicitly. These tables are treated as just described:
mysql.help_category mysql.help_keyword mysql.help_relation mysql.help_topic mysql.proc mysql.time_zone mysql.time_zone_leap_second mysql.time_zone_name mysql.time_zone_transition mysql.time_zone_transition_type
If you want to explicitly place a
on any of those tables with a
TABLES statement, the table must be the only one
locked; no other table can be locked with the same statement.
Normally, you do not need to lock tables, because all single
UPDATE statements are atomic; no
other session can interfere with any other currently executing
SQL statement. However, there are a few cases when locking
tables may provide an advantage:
If you are going to run many operations on a set of
MyISAM tables, it is much faster to lock
the tables you are going to use. Locking
MyISAM tables speeds up inserting,
updating, or deleting on them because MySQL does not flush
the key cache for the locked tables until
TABLES is called. Normally, the key cache is
flushed after each SQL statement.
The downside to locking the tables is that no session can
READ-locked table (including the
one holding the lock) and no session can access a
WRITE-locked table other than the one
holding the lock.
If you are using tables for a nontransactional storage
engine, you must use
TABLES if you want to ensure that no other session
modifies the tables between a
SELECT and an
UPDATE. The example shown
LOCK TABLES to
LOCK TABLES trans READ, customer WRITE; SELECT SUM(value) FROM trans WHERE customer_id=
some_id; UPDATE customer SET total_value=
some_id; UNLOCK TABLES;
You can avoid using
in many cases by using relative updates (
See Section 18.104.22.168, “Transaction and Atomic Operation Differences”.
You can also avoid locking tables in some cases by using the
user-level advisory lock functions
RELEASE_LOCK(). These locks are
saved in a hash table in the server and implemented with
pthread_mutex_unlock() for high speed. See
Section 12.16, “Miscellaneous Functions”.
See Section 8.10.1, “Internal Locking Methods”, for more information on locking policy.
Copyright © 1997, 2014, Oracle and/or its affiliates. All rights reserved. Legal Notices